Thurrock Kitchens and Bathrooms handles complete kitchen and bathroom refurbishments in Thurrock, renovating both rooms in one project under one contract. A single project manager runs every trade, from taking out a load-bearing wall to fitting the last tap, so you are not left chasing builders, electricians and tilers on two jobs at once.
Doing both rooms together saves time because the trades work in one sequence. The structural work and RSJ steel go in first, plumbing and Part P electrics are rerouted around the new layouts, then the bespoke cabinetry, quartz worktops, wet room and large-format porcelain floors follow. Wet areas are tanked behind moisture-resistant boards, and Part F extraction in both rooms deals with the damp air near the Thames Estuary.
Most dual-room refurbishments take 3 to 5 weeks, depending on the structural work. You get an itemised, fixed-price quote before anything is stripped out, and every certificate at the end.
Get a FREE Quote

Taking out a dividing wall is often what turns a cramped kitchen into a family space. A structural engineer's calculations set the size of the RSJ, its bearing points and the concrete padstones, and building control inspects the steel before it is covered. We plan the wall removal around the plumbing and electrics, so the services move once, not twice.

Moving a sink, toilet or shower means moving the pipes that serve it. Supplies, isolation valves, wastes and 110mm soil pipes are run to the new positions at first fix, before the walls and floors are closed. Our plumbers pressure-test every run at this stage, which saves opening finished walls later.

A refurbishment adds circuits for ovens, hobs, showers and underfloor heating, and an older board is often not up to the job. Thurrock Kitchens and Bathrooms fits RCBO consumer units with surge protection, so each new circuit has its own protection. Our electricians test and certify the board under Part P before handover.

Quartz is fabricated off site, so the measurements have to be right first time. We laser template the kitchen once the cabinets are fitted, and the stone is cut with precise edges, joints and openings for the sink and hob. The non-porous surface resists stains and needs no sealing.

A level-access wet room replaces the raised shower tray with a flush floor that falls to the drain. Floor formers, linear drains and a tanking membrane go in beneath the tiles, and our fitters check the falls before tiling starts. The result is a shower with no step to trip over and a floor that clears water quickly.

Large-format porcelain cuts the number of grout lines across a kitchen or bathroom floor. The substrate is prepared and a decoupling membrane laid where the floor might move, then the tiles go down with a levelling system for flat joints. We set out the floor from the centre of the room, so the cuts at the walls and thresholds come out even.
Both rooms follow one structured sequence, so each trade picks up where the last one finished.
Our Thurrock Kitchens and Bathrooms surveyor measures both rooms and checks the load-bearing walls and drainage routes. That confirms the new layouts work before any work begins.
Old units, tiles and sanitaryware are stripped back to bare walls and floors. Any RSJ steel goes in and is inspected by building control.
New pipework and cabling are run through the walls and floors. Walls and ceilings are then boarded and plastered once the first fix is checked.
Kitchen units and the bathroom suite go in alongside the wall and floor tiling. Quartz worktops are templated and fitted once the cabinets are level.
Fittings and appliances are connected and tested, and we walk through both rooms with you. You receive every electrical and building control certificate at handover.
A full dual-room refurbishment typically takes 3 to 5 weeks, depending on the scope and any structural changes.


The cost of a complete refurbishment from Thurrock Kitchens and Bathrooms depends on the structural work, how much plumbing and wiring changes, and the grade of cabinetry, quartz and porcelain you choose.
Our 3 guide price bands, covering both rooms, supply and fit:
Our refurbishment scope | Guide price range (supply and fit) | What you get |
|---|---|---|
Essential dual-room refresh | £14,000 – £22,000 | Rip-out, direct replacement kitchen units, laminate surfaces, family bathroom refit, like-for-like plumbing, full tiling |
Complete turnkey renovation | £22,000 – £38,000 | Full strip-out, minor partition moves, consumer unit upgrade, bespoke shaker kitchen, quartz worktops, walk-in shower room |
Luxury open-plan and master suite transformation | £38,000 – £65,000+ | Load-bearing wall removal with RSJ beam, island kitchen with waterfall quartz, wet room conversion, underfloor heating throughout |
What pushes a quote towards the top of a band:
Your quotation follows an on-site survey of the load-bearing structure, drainage routes and electrical supply, so it reflects the actual condition of your home.
Yes. One project manager runs our plumbers, electricians, plasterers and tilers, so you have a single point of contact throughout.
Yes. We remove load-bearing walls as part of the refurbishment, working from a structural engineer's calculations and installing the RSJ ourselves.
Most of our dual-room refurbishments take 3 to 5 weeks, depending on the scope and any structural changes.
Yes. We deal with Thurrock Council building control on your behalf and hand you the completion certificate when the work passes.
Yes. You receive a written, fixed-price quote covering the full scope of both rooms before any work begins.
A refresh covers cosmetic updates such as new doors, worktops or a replacement suite. A full refurbishment with us strips both rooms back and replaces the units, wiring, plumbing and flooring.